there should be plenty of tutorials on youtube, i personally learned by just doing. started just playing around on what everything did until i finally realized what works best with what. there is a reasonably learning curve on this though.
HSM is only a gcode generator, it works with just about any machine you can think of, so its not exactly about how to make it work with the xcarve. but as a general idea on how to make it work. after you design you file, you make all the operations (g-code) and save it to an “*.nc” file from there you take that file that you just made and upload it to a gcode sender such as UGS or chilipeppr ( i use chilipeppr) and your pretty much done.
for a more in depth explanation on how everything works then you can PM me and ill try to help you as much as i can,
for the most part though if you hover your mouse over all the operations, it gives you a small window of what that operation is and what its used for
