That looks amazing. Glad you had really good luck with yours………?!
I think I carved too deep……1/8” cut depth….I used cheap epoxy from craft a craft store….and my boards weren’t very level.
The epoxy overflowed a lot onto the board where I did not want it to go. I could not sand it off at all, turned it to warmed up shredded rubber.
Also what did look good within the carve had a crazy amount of bubbles. I tried using a torch and got a little bit out but not near enough to even get that little section to look good.
I didn’t even take pictures….I then lit them on fire in backyard. LOL