All,
I just got off of the phone with Tec Support at Inventables. Found the solution (we believe), and that is using the ‘off-setter’ app, which will allow me to enlarge (or shrink) the design and keep the lines parallel.
I might not be able to get to this until tomorrow. I’ll check back in to let you know how it went.
Also, I got the answer concerning the cut types. As you know - and I did not - the cut types from which one must choose when bring in an image, is the same as the cut settings in the cut drop-down - despite the fact that the names are different. I made the request (begged actually) that they make the naming convention the same so that the uninitiated such as myself won’t get stuck on this in the future.
so… I have my marching orders, wish me luck.
thanks to all of you!
(I appreciate that this forum exists, I feel a bit like a babe in the woods, and love that those of you with knowledge are willing to share and help.
All my best,
Joe