I changed the depth of cut to rough then back to finish worked great
Phil, I used this feature for the 1st time this past weekend and it worked fine for me. I pocketed a large area with a 1/4" end mill and then finished the edges and radiuses with an 1/16" end mill. I was also able to reduce the feed and the DOC of my finishing end mill.
Chachin…
1 Like
Would love to try this feature, with my New Xcarve
Sign me up as a trial user please.
@AndrewFreeston @StevenSmith @Scotts You guys have access!
Thanks for the access Eric. Are there plans to be able to set the speed/feed for each bit?
I don’t have the motorlock buttons on my X Carve controls. Help?
We are looking into it, and will try to get it into Easel before this feature comes out of Early Access. I can’t give you an ETA, sorry.
1 Like
Could I get accessssss?
I’d like to be a trial user as well. I’ll give feedback.
Id like very much to try two stage cuts aswell 
Can I get access to this feature as well?
@Thor You have access!
i would love access as well
@ToddMPuchovan Welcome to the club!
I would love access please!!! Thank you!
@BrentSancken You got it, bud!
Could I get access to this feature please? Thank you!
Could I be added to the list as well please? Thank You!
Could I please have access? Thanks