I have an ogee bit that I would like to use on the outside edge of a plaque. I have not been successful in going around an edge. How do you set up the bit to follow the edge? I can get the bit to follow on three edges but the fourth is way out of line. Do you use the outside diameter? Any hints…

All of mine I’ve been just cutting it out, then using the edge treatment with my standard router table.

Are you using the standard spindle with the ogee bit? I wouldn’t recommend that as it puts a ton of load on the motor and will slow it down considerably. As Dan mentioned, probably the best way would be to cut the piece out with square edges and then route them by hand or on a table. However, If …

Yes, I am determined to give this a try. To reduce load I would take progressively small cuts in depth. I have calculated the 1/2 diameter and set that into my size. Doesn’t seem to work. The tool path sometimes wonders off, my fix has been to do a new project. But I am still having trouble set…

Another option to form an edge of a plaque is a bit with no bearing, such as the ones on this page .

I am using a bit without a bearing. I think that my real problem is not understanding how to set up the bit with Easel. It doesn’t end up where I expect it to. In order to understand better I have set up a sheet to track my entries into Easel but Easel seems to change some things and I am at a lo…

So you’re having problems with the machine’s accuracy then? Can you try to run the job without the bit installed and with the spindle up higher so it won’t cut, and see if it follows the path it’s supposed to? If it doesn’t, there might be something wrong with either your machine (belts too loose/…

Easel Community Forum

Using an Ogee router bit to carve the edge of a plaque

Projects

ErikJenkins July 25, 2015, 1:32am 2

One thought is to put another vector around the shape you are tracing, just a bit larger to offset the size of the ogee bit and follow that path.