Carving stops same spot every time w/console alarm error?

Easel Easel Pro
1

I’ve been running the same file for over 8 months, and have not changed it in quite some time (we make the same product repeatedly).

After installing the 0.3.16 driver about a week ago I’ve been having a strange issue where the carve is stopping in roughly the same exact spot, and throws an alarm in the console. Any thoughts on what this might be?

image
image584×506 5.31 KB

TIA

1 Like
2

figured it out!!

A wire coming out of the Y wire-track was getting snagged on the stop switch if the gantry went Y+ far enough and then came back… serves me right for trying to clean up the shop and moved things around a bit. :wink:

1 Like